Publicité
Les langues disponibles
Les langues disponibles
Wireless Connection
Notification Light
MULTI FUNCTION DISPLAY
Power
Figure 17a
Mounted Multi Function Controls Panel
Power
Manual /
Automatic
Toggle
Rate Select
Temperature
Decrease
Temperature
Increase
Figure 17b
Remote Controller
Mounted Button Functionality: Normal Operation
• The light illuminates when the stove is
plugged into an electrical supply.
• Press the power button to turn the display
on for the purpose of adjusting settings.
The screen will become dim after 10
seconds on inactivity.
• Press and hold the power button for 3
seconds to begin stove heating if the stove
was off.
• Press and hold the power button for 3
seconds to begin stove shut off if the stove
was on.
CAUTION: The manufacturer has programmed
preset rates to ensure proper operation. It is not
advised to reprogram rate settings.
Master Forge Wood Pellet Fire Stove
H30XL MULTI FUNCTION CONTROLS
Rate Select
Display Screen
Auto
17
Manual / Automatic
Notification Light
Settings
Time
Press to cycle between temperature reports
(in Fahrenheit) display in the top right of
the multi function display screen:
• ##(R): Room temperature
• ##(S): Exhaust temperature
• ##(P): Protection Temperature Sensor
Press to increase the temperature which the
stove is intended to heat the room to. This
value is displayed in the top right of the
multi function display screen as ##
Press to decrease the temperature which
the stove is intended to heat the room to.
This value is displayed in the top right of the
multi function display screen as ##
Press to toggle the stove between manual
control and programmed control. If the
stove is in the program controlled setting
then the notification light
illuminated.
Pressing the rate select will toggle between
four configurable heating presets. The
currently set preset is available in the top
middle of the multi function display screen
as P#.
• P1 [High Power] Settings
• P2 [Medium-Plus Power] Settings
• P3 [Medium Power] Settings
• P4 [Low Power] Settings
• Press and hold the settings button for 2
seconds to enter the set up menu.
• Press the settings button at any time to
exit the set up menu.
Operating Instructions and Owner's Manual
Confirm
Up Selector
Down Selector
0
F.
F.
0
will be
Publicité
