Broan-NuTone AVDF1 Serie Manuel D'installation, D'utilisation Et D'entretien page 9

Prepare the Hood
NOTE: Since this manual covers many range hood models, some details in the following
illustrations may sligthly differ from your unit.
1 ] If present, remove all protective polyfilm from the hood and/or parts.
2 ] Using the finger cup (AVDF1, AVSF1-2 Series) or the tab (AVSF1 Series), remove the grease
filters from the hood by pushing down
B
3 ] Remove the EZ1 brackets from inside the hood by cutting off the tie wrap. Remove both
screws holding damper assembly to hood. Remove parts bag (captured behind the damper
assembly). Remove damper assembly from inside the hood and keep the screws for further
use.
EZ1
BRACKETS
4 ] Remove the wiring cover (shaded part on illustration below) by sliding it out from the hood
and set it aside.

and tilting filters out
C

.
SCR EWS
DAMPER
ASSEMBLY
9