Image Resolution; Image Quality - Indexa DF400 Mode D'emploi

is opened, when the storage is full (only when the ring function is disabled) and also through the App when in „remote record settings" the corresponding
button is moved to the left or when „remote settings" is selected.
Manual recording audio/video from all cameras
By clicking this symbol all activated cameras will be recorded, irrespective of which display mode is on the screen.
Successive files, each approx. 5 minutes long, will be recorded until the recording is stopped. This happens when the symbol is reclicked, when the main menu
is opened, when the storage is full (only when the ring function is disabled) and also through the App when in „remote record settings" all the camera
buttons are moved to the left or when „remote settings" is selected.
12.3 Main menu (see fig. D)
[43] Camera settings (see fig. E)
Select in the left column the camera channel 1 to 4 [48] for which the following can be set:
[49] Pairing (pair camera with a channel)
To pair a camera to a channel, click this symbol until „Pairing..." is displayed. Within 35 seconds hold the pairing button [27] on the
camera pressed for aprox. 2 seconds. The successful pairing is displayed as „Pairing OK"
[50] Activate or deactivate camera
Click on this symbol until the required setting „I" (activated) or „0" (deactivated) lights red.
Factory setting: 1 and 2 activated, camera 3 and 4 deactivated
Note:

[52] Image resolution

Click on this symbol until the required setting „High" (higher resolution, more pixels, causes lower frame rate) or „Low" (lower
resolution, less pixels, causes higher frame rate) is displayed.
Factory setting: High
Note:

[51] Image quality

Click on this symbol until the required setting „High" (higher image quality, causes lower frame rate) or „Low" (lower quality, causes
higher frame rate) is displayed.
Factory setting: High
[44] Recording Settings (see fig. F)
[53] Record schedule (select time period and method of automatic recording)
Factory setting: all cameras record upon motion detection, all day, every day
•
•
Note: If another camera is selected without saving the setting for the previous camera, then the settings for the previous camera will not
[54] Method of motion detection
By clicking repeatedly on the desired camera the desired setting can be made
PIR
PIR and additionally motion detction via pixel changes (low, middle, high)
Note: The sensitivity and detection area of the PIR sensor are fixed, it reacts within a horizontal angle approx. 60°.
44 - GB
The data from a deactivated camera cannot be displayed or recorded
If image detail is important select „High". If a higher frame rate is important or if the system is to be operated only through
the App then select „Low".
For a different selection as „all cameras" [57] click once with the right mouse button. Now select in the top row a camera for which
the recording is to be set.
Set the five periods (corresponding to the 5 lines [58]) for this camera.
• Click on the grey area to the left to select the method of recording:
in the set period the motion detection is active
constant recording in the set period
empty area no (automatic) recording
• Select the days for which the recording is appicable (only one day / daily / Monday to Friday / Monday to Saturday).
• Set the start time and end time for the recording period with hour (24 hour clock) and minute.
• After setting the time period, click with the right mouse button until „saving settings. Please wait..." is displayed.
• After the settings have been saved then repeat for another camera if required.
be saved.
Motion detection only via PIR sensor on the camera (Factory setting)
PIR sensor and additionally motion detction via software through pixel changes (low, middle, high sensitivity) in
preselected areas of the camera image.
•