Philips 800 Serie Mode D'emploi page 5

Do not use the appliance near gas appliances, heating devices or fireplaces.
•
Always turn off the air purifier first, then unplug adapter from wall outlet, when you want to
•
moving, cleaning appliance, replacing the filters or carry out other maintenance.
The appliance is only intended for household use under normal operating conditions.
•
Do not use the appliance in wet surroundings or in surroundings with high ambient temperatures,
•
such as the bathroom, toilet, or kitchen, or in a room with major temperature changes.
The appliance does not remove carbon monoxide (CO) or radon (Rn). It cannot be used as a safety
•
device in case of accidents with combustion processes and hazardous chemicals.
Electromagnetic.fields.(EMF)
This appliance complies with the applicable standards and regulations regarding exposure to
electromagnetic fields.
FCC & ISED Compliance
Please take attention that changes or modification not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
RF Exposure Information
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. This equipment should be installed and operated with a minimum distance of 20 cm
between the radiator and your body.
For the United States
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
For Canada
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two
conditions:
1.This device may not cause interference.
2.This device must accept any interference, including interference that may cause undesired operation
of the device.
Disposal
Your product is designed and manufactured with high quality materials and components, which can be
recycled and reused. For recycling information, please contact your local waste management facilities
or visit www�recycle�philips�com�
EN
3