Bosch JS365 Consignes De Fonctionnement/Sécurité page 9

BM 1609P07165 08-11:BM 1609P07165 08-11 8/10/11 8:58 AM Page 9
ATTACHING NON-MARRING OVERSHOE
Your tool is equipped with a protective plastic
overshoe that protects finer surfaces.
To attach, hook overshoe over front of metal
footplate and snap into place at rear of
footplate (Fig. 6).
ANTI-SPLINTER INSERT
To minimize splintering of the top surface of
the material being cut, place the JA1008 anti-
FIG. 6
1
PLUNGER SPEED
The jigsaw cutting speed or stroke rate
required depends on the material being cut,
the type of blade being used, and the feed rate
preferred by the operator.
The best speed for a particular application is
largely determined by experience though as a
general rule, slower speeds are for denser
materials and faster speeds for softer materials.
Note that when the jigsaw is used at low speed
settings for an extended length of time, the
motor temperature will rise due to slower
speeds of the internal cooling fan. In such
cases, it is necessary to occasionally run the
tool at full speed for a few minutes to keep the
motor running at high efficiency.
VARIABLE SPEED DIAL
Your jigsaw is equipped with a variable speed
dial. The blade stroke rate may be adjusted
during cutting operation by presetting the dial
on or between any one of the six numbers
(Fig. 1).
Setting
1-2 Low stroke rate
3-4 Medium stroke rate
5-6 High stroke rate
splinter insert in the blade opening of the
footplate (Fig. 7).
Note: This insert will only work with blades that
have ground sides such as T301CD, T101B,
T101D, and T101DP.
Note: When the insert is used with the non-
marring overshoe, the anti-splinter insert has
to be placed in overshoe.
FIG. 7
2
ANTI-SPLINTER
INSERT
NON-MARRING
OVERSHOE
Operating Instructions
Your tool is equipped with a variable speed trigger
switch. The tool can be turned "ON" or "OFF" by
squeezing or releasing the trigger. The speed can
be adjusted from the minimum to maximum SPM
as set on the variable speed dial by the pressure
you apply to the trigger. Apply more pressure to
increase the speed and release pressure to
decrease speed (Fig. 1).
Regardless of the pressure applied on the
trigger, the tool will not operate any faster than
maximum speed setting selected on the
variable speed dial.
The "Lock-ON" button, located in the handle of
your tool allows for continuous operation at
maximum preset SPM without holding the
trigger (Fig. 1).
TO LOCK TRIGGER "ON": squeeze trigger,
depress button and release trigger.
TO UNLOCK THE TRIGGER: squeeze trigger
and release it without depressing the "Lock-
ON" button.
the trigger can not be released.
-9-
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
"LOCK-ON" BUTTON
If the "Lock-ON" button is
WARNING
continuously being depressed,
FOOTPLATE