Bosch JS365 Consignes De Fonctionnement/Sécurité page 8

BM 1609P07165 08-11:BM 1609P07165 08-11 8/10/11 8:58 AM Page 8
BLADE INSTALLATION AND REMOVAL
This jigsaw is equipped with a Bosch tool-less
blade changing system for fast and easy
changes of T-shank blades. (Note: This jigsaw
does not accept U-shank blades.)
If blade is not properly
WARNING
installed, then the blade may
unexpectedly dislodge from jigsaw when tool is
energized.
1. Pull the blade change lever to the point that
the slots on the blade clamp's ring line up with
the slot in the center of the clamp (Fig. 2).
BLADE CHANGE
LEVER
SLOT
BLADE CLAMP
RING
2. To remove a previously-used blade, simply
pull it out of the blade clamp.
3. Insert the saw blade (teeth in cutting
direction) until it the "T" part of the blade shank
is completely inserted in to the blade clamp.
DUST EXTRACTION
(Not included, available as accessory)
The JA1009 Dust Extraction Kit includes a
dust shroud and an extraction tube for
connecting the jigsaw to a vacuum hose or
vacuum hose adapter.
Note: The dust shroud must be used when the
extraction tube is connected to a vacuum
cleaner system.
To use this feature, attach extraction tube to
footplate. When inserting the extraction tube
FIG. 4
EXTRACTION TUBE
(Not included, available
as accessory)
Assembly
FIG. 2
SLOT
SLOT
DUST SHROUD
(Not included, available
as accessory)
PLASTIC
POST
-8-
(When inserting the saw blade, the back of the
blade must rest in the groove of the guide roller)
(Fig. 3.)
4. When blade change lever is released, it will
spring back to its closed position.
5. Verify that the blade clamp has also
returned to its closed position (which is the
point where slots were previously).
Note: If the saw blade cannot be inserted into
the plunger, the slots of the blade holder are
not in the correct position.
BLADE
CHANGE LEVER
BLADE
into the footplate be sure that the plastic post
of the extraction tube engages into the
corresponding hole on the housing (Fig. 4).
For vacuuming, a Bosch Air Sweep vacuum
hose or hose adapter (optional accessory) can
be directly connected to the extraction tube
(Fig. 5).
For maximum vacuum dust pick up, dust
shroud must be attached.
1-1/4" OR 1-1/2" VACUUM HOSE
(Not included, available as accessory)
VAC024
EXTRACTION TUBE
(Not included, available
as accessory)
FIG. 3
BLADE CLAMP
FIG. 5
VACUUM HOSE
(Not included,
available as
accessory)