Timer Function; Cleaning - SilverCrest SSVF 45 A1 Mode D'emploi

Timer function

With the timer function, you can set a time
after which the fan automatically switches
off. You can set a time between 0.5 and
7.5 hours in 0.5-hour steps.
• When the device is switched on, repeat-
edly press the TIMER 22/ 32 but-
ton. Each time you press it, half an hour
is added. The lit LEDs 20 indicate the
time that has been set. Add up the times
of the lit LEDs to get the set time:
- 0.5: Half an hour
- 1: 1 hour
- 2: 2 hours
- 4: 4 hours
Example:
The following LEDs are lit:
0.5 + 1 + 4.
This means that the timer is set to:
0.5 + 1 + 4 hour = 5.5 hours.
• While the timer is running, the LEDs 20
show the remaining time.
• After the set time has elapsed, the de-
vice switches off.
• To switch off the timer function early,
press the TIMER 22/ 32 button re-
peatedly until all LEDs 20 have gone
out or switch off the device.

9. Cleaning

In order to enjoy your device for a long time,
you should regularly clean it.
DANGER! Risk of electric
shock!
Before cleaning, pull out the mains
plug 9.
Never immerse the device in water.
Do not let water or cleaning agent run
into the device.
WARNING! Risk of material damage!
Do not clean using sharp objects or
abrasive cleaning agents.
Protective grid/rotor blade
• Carefully remove coarse dust deposits
with a vacuum cleaner, preferably with
a small brush nozzle.
• If necessary, loosen the connecting
screw 18, open the hinged connections
and remove the front protective grid 1.
• Be careful not to bend the rotor
blade 3.
• Replace the front protective grid 1 be-
fore reconnecting the device.
Remote control
• Clean the remote control 31 with a dry
cloth.
Device
1. Clean the outside of the other parts of
the device with a damp cloth. You can
also use a little detergent.
2. Dry with a soft cloth.
3. Do not use the device until it is com-
pletely dry again.
13
GB