Before Assembly - STARFRIT THE ROCK Manuel D'utilisation

GROUNDED PLUG: As a safety feature, this appliance is equipped with a grounded plug,
which will only fit into a three-prong outlet. Do not attempt to defeat this safety feature.
Improper connection of the grounding conductor may result in the risk of electric shock.
Consult a qualified electrician if you are in doubt as to whether the outlet is properly
grounded.
SPECIAL INSTRUCTIONS: A short power supply cord is provided to reduce the risk of
becoming entangled in or tripping over a longer cord.
AN EXTENSION CORD MAY BE USED IF CARE IS EXERCISED IN THEIR USE:
- Minimize the risk of overheating by using the shortest UL or ETL listed cord possible.
- The marked electrical rating must be at least as great as that of the product.
- Never use a single extension cord to operate more than one appliance.
- If the product is of the grounding type, the extension cord must be a grounding-type 3-wire
cord.
- Arrange the longer cord so that it will not drape over a countertop or tabletop where it can
be tripped over, snagged, or pulled on unintentionally (especially by children).
DO NOT alter the plug. DO NOT attempt to defeat the safety purpose of the polarized plug.

BEFORE ASSEMBLY

Before assembling the product, thoroughly clean the Base as instructed in
Steps 3-5 of the "Care and Maintenance" section.
TO ASSEMBLE
CAUTION: Ensure the Temperature Control Dial is set to "OFF," the Power Cord is unplugged
from the electrical outlet, and the product has thoroughly cooled before attaching or
detaching the Temperature Control Dial. Do not use multi-use pot without handles attached.
1. Place left handle onto mounting studs underneath (side of) multi-use pot.
2. Use screwdriver to attach 2 screws through holes in the handle into the multi-use pot.
3. Place right handle onto mounting studs underneath (side of) multi-use pot.
4. Use screwdriver to attach 2 screws through holes in the handle into multi-use pot
CAUTION: Overtightening can result in stripping of screws or nuts or cracking of handle
or feet.
5. Attach the knob to the lid by aligning the hole in the knob with the hole in the lid, and
then secure with bolt and washer. NOTE: Do not over-tighten the bolt.
4