Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
― ―
1.
Take the two parts of the base, align the centres and snap them together as shown in fig 1.
2.
Connect the main body of the unit to the base by lining up the front and the back of the unit
with the highlighted clips in fig 2.
3.
Affix the four screws provided with a Phillips screwdriver to the four holes highlighted in fig 3.
8 of 124 | English
Fig 1.
Fig 2.
Fig 3.
CONTROL PANEL
― ―
Power Button
This is the power button. Press to turn the unit on/off. When the unit is on,
the
indicator light will light up.
Fan Speed
This is the fan speed button. Press to cycle through the three wind speeds
Button
low
, medium
and high
Mode Button
Press this button to cycle through the fan, night
For full instructions see the "Operating Instruction" section on page 11.
Timer Button
Press this button to set a timer from 1h-7h. Though the indicator lights only
show 1h, 2h, and 4h options, the lights will add up for options 3h, 5h, 6h and
7h: 1h + 2h = 3h / 1h + 4h = 5h / 2h + 4h = 6h / 1h + 2h + 4h = 7h
Oscillation
Press this button to turn oscillation on or off.
Button
Humidification
Press the button to activate the humidification mode. This mode can work
Button
with all other modes (fan-only, night and natural). For full instructions see
the "Operating Instructions" section on page 11.
NOTE: The display lights on the control panel will turn off after 60 seconds. To see your current
settings either tap any button on the control panel or remote control (apart from the Power Button)
and the control panel lights will automatically turn on.
.
and
natural modes.
English | 9 of 124
Publicité
