Polar G608 Mode D'emploi page 5

Set the Operating Temperature
1. Press the SET button for 3 seconds. The display will
flash.
2. Press the or
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
Press and hold the defrost button "aux" for 2 seconds
to begin a manual defrost. The defrost light illuminates.
The defrost cycle will end automatically.
Cleaning, Care & Maintenance
Switch off and disconnect from the power supply before cleaning.
•
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with warm soapy water.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
• Take care when cleaning the rear of the appliance. Sharp edges can cut.
Condensation and ice will form with frequent and prolonged opening of the doors.
Operating outside of the recommend temperature range and placing next to a heat source
will also increase the amount of ice and internal/external condensation. If external
condensation occurs wipe the surface down with a cloth.
Excessive ice will result in longer running times that will increase energy consumption and
increase the deterioration of components.
Cleaning the Condenser Filter
• The condenser is part of the refrigeration system. The
condenser filter requires monthly cleaning.
• Always disconnect power supply before carrying out Routine
Maintenance.
• Failure to clean the condenser filter will reduce the
performance and life of your Polar unit and may invalidate
your warranty.
• These models have a removable filter which can be cleaned
with a vacuum cleaner.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is not
working
G608-G611_GD875-GD878 _ML_A5_v9_20240403.indb 5 G608-G611_GD875-GD878 _ML_A5_v9_20240403.indb 5
buttons to display the
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Solution
Check unit plugged in correctly and
switched on
Replace Plug or lead
Replace the fuse
Check mains power supply
EN
5
2024/4/3 16:59 2024/4/3 16:59