3M PELTOR PIC-100 NA Guide De Configuration Rapide page 11

The daily check procedure begins and can be observed by the
white channel light indicators (1) described below. The process
takes about 5 seconds.
LED indicators
All LEDs are blinking Daily check is
white running. White
lights blinking.
All LEDs lit green Daily check is
successful on
both left and right
earpieces.
A = Green Daily check
B = Red failure on left
earpiece. Red (B)
LEDs illuminate.
A B
A = Red Daily check
B = Green failure on right
earpiece. Red (A)
LEDs illuminate.
A B
All LEDs lit Red Daily check
failure on both left
and right
earpieces. Red
LEDs illuminate.
10. FITTING INSTRUCTIONS
Inspect the hearing protector before each use. If damaged, select
an undamaged hearing protector or avoid the noisy environment.
10.1. PREPARE THE EARPLUGS
Select the correct size of the eartip
The packaging includes 3 sizes of 3M™ UltraFit™ Communication
Eartips (small, medium and large), 1 pair of 3M™ Skull Screw™
Communication Eartips and 1 pair of 3M™ PELTOR™
CCC-GRM-25 Communication Eartips.
Description What to do
No action
required.
No action
required.
Microphones
are functioning
properly.
Ensure the
environment is
suitable to
conduct the
test, remove
any debris from
the earpiece
stem or from
around the
microphone
cover and
repeat daily
check.
Ensure the
environment is
suitable to
conduct the
test, remove
any debris from
the earpiece
stem or from
around the
microphone
cover and
repeat daily
check.
Ensure the
environment is
suitable to
conduct the
test, remove
any debris from
the earpiece
stem or from
around the
microphone
cover and
repeat daily
check.
3M™ UltraFit™ Communication Eartips
1. To choose the appropriate 3M™ UltraFit™ eartip size, begin
with the medium size.
2. Ensure that it is small enough to penetrate the ear canal and
provide a secure fit, but also large enough that at least one
flange seals the ear canal at the canal entrance.
3. If the medium size does not provide a proper fit, proceed with
the small or large size eartips as these were designed to fit
users for whom the medium size is not suitable.
3M™ Skull Screw™ Communication Eartips and
3M™ PELTOR™ CCC-GRM-25 Communication
Eartips
With the 3M™ Skull Screw™ and 3M™ PELTOR™ CCC-GRM-25
Eartips, one size is intended to fit most.
WARNING! Do not use product if the proper size and fit
cannot be obtained.
CAUTION: Use only 3M™ PELTOR™ Eartips designed for use
with this product. Do not insert the earpiece directly into the ear
without a correctly attached 3M™ PELTOR™ Eartip.
Attaching the eartips
NOTE: Make sure to handle the eartips with clean hands.
1. Push eartip onto the eartip stem.
EN
7