Foot Controller - Singer 4166 Mode D'emploi

FOOT CONTROLLER

Use of foot controller will permit control of start, stop and speed with your foot.
!
CAUTION: To prevent accidents.
1.Turn off the power switch.
2.Push foot controller plug into receptacle on machine.
3.Place foot controller at your feet and turn on power switch.
Sew faster by increasing the pressure on the controller.
To stop, remove your foot from the controller.
CONTROL BUTTON FUNCTIONS
The control button functions described in
previous page will change when the foot
control is connected.
A.START/STOP BUTTON
This button will be deactivated.
B.SPEED CONTROL BUTTON
This button will limit the maximum speed.
C.REVERSE STITCH BUTTON
The machine will continue to sew reverse at same speed while this button is pressed.
When released, the machine will continue to sew forward.
WARNING:
!
-To reduce the risk of burns, fire, electric shock, or injury to persons.
1.Handle the foot controller with care and avoid dropping it on the floor. Be sure not
to place anything on top of it.
2.Use only foot controller provided with this machine.
1
SAFETY FEATURE OF ELECTRONIC MODEL
If the machine is jammed, it will stop with three
beep sounds. After the cause of jamming is
removed, step on the foot control and it will
run in normal condition.
-9-
2