Technical Specifications - VINCENT SV-232 Manuel D'utilisation

Symptom
Front panel display
does not work
Poor sound quality
The remote control
cannot perform any
functions
Humming low
frequency noise is
audible, even as
no audio source is
playing back
Frequency response:
Nominal Output Power at 8Ω:
Nominal Output Power at 4Ω:
Input sensitivity:
Total Harmonic Distortion:
Signal to Noise Ratio:
Input Impedance:
AC power connection type:
Inputs:
Outputs:
Dimensions:
Weight:
Colour:
Vincent
42
Possible Cause
It has been switched off before using "DIM-
MER" (8)(18).
The cable connections are not tight, the con-
nectors are dirty or a cable is defective.
A record player has been connected to a line
level input without using a phono preamplifier.
An audio source with standard line level out-
put is connected to the amplifier direct input
"LINE6" (12).
No batteries inserted in the remote control,
batteries are not inserted correctly or are
depleted.
The line-of-sight between the remote control
and the unit is obstructed, the range was
exceeded or the hand unit was operated from
a position too far to one side.
The unit is not switched on.
See section "Net frequency noise" in the chapter "Tips".

TECHNICAL SPECIFICATIONS

20 Hz - 20 kHz ±0.5 dB
20 Hz - 50 kHz ±2 dB
2x 100 W (RMS)
2x 180 W (RMS)
260 mV
< 0.1 % (1 kHz, 1 W)
> 90 dB
47 kΩ
230 V/50 Hz
5x RCA stereo, 1x RCA Main Input stereo,
1x Power Control (3.5 mm jack connector)
4x2 loudspeaker sockets, 1x PRE stereo RCA,
1x REC stereo RCA, 2x Power Control (3.5 mm jack connector)
430 x 135 x 390 mm
13.8 kg
silver / black
Countermeasure
Press the button "DIMMER" (8)(18) one more
time.
Check the cables and cable connections.
Interconnect a phono preamplifier.
Use line level audio sources only at the inputs
"LINE1"..."LINE5".
Check and replace the batteries if necessary.
Try to point the remote control at the front of
the unit only when the sight-line is clear,
within a 7-metre distance and, if possible,
facing the unit.
Switch on the unit.