Subaru SOA801P091 Serie Manuel D'installation

INSTALLATION
INSTRUCTIONS
KIT CONTENTS:
TOOLS REQUIRED:
ISOPROPYL
ALCOHOL
*Sealant Adjustment
Isopropyl
Tool Part #:
Alcohol
SOA801AT100
It is strongly recommended that this product be installed by your Subaru Retailer.
NOTE: If installing Body Side Moldings along with Door Edge Guards, the Body Side Moldings must be installed first. This is required for proper positioning of
the two accessories. If the vehicle has Body Side Moldings previously installed and the distance between the edge of the Body Side Molding and edge of the
door is less than 5mm, the Door Edge Guards will not be able to be installed due to spacing issues.
MEANING OF CHARACTERS:
: CAUTION – A process that must be
carefully observed in order to reduce the
risk of damage to the accessory/vehicle
and to ensure a quality installation.
STEP ONE: Prepare the Door's Surface
1a
Before installation, confirm there is sufficient clearance between the door edge and the sealant bead for proper seating of the Door Edge Guard.
SUFFICIENT CLEARANCE
Figure A
To adjust the seam sealer clearance when less than 2 mm exists between the door edge and the seam sealer, align the "green arrow"
on the Sealant Adjustment Tool with the inside of the door's edge. Place the pushing edge in the crease where door sealant bead and
metal meet on the inside of the door (Figure C). Lightly push sealant adjustment tool in order to move sealant for preparation of
install. It is critical that close attention be paid to the first 18mm of the sealant bead going down from the top where the Door Edge
Guard starts and the last 18mm at the bottom where the Door Edge Guard ends for proper Door Edge Guard retention
PART NUMBER:
SOA801P091-XX
DESCRIPTION: Crosstrek Door Edge Guard
Door Edge Guard 4 pc.
Lint-Free Towel
Scissors
: STOP - Damage to the vehicle may
occur. Do not proceed until process has
been complied with.
CHECK SEALANT IN AREAS INDICATED BY
ONLY USE THE TOOL IN THE AREA THE DOOR EDGE GUARD WILL BE INSTALLED
Looking Down the Door Edge
INSUFFICIENT CLEARANCE
DATE:
ISSUE:
11-01-2022
REV. – A
PART NUMBER: SOA801P091-XX
Painter's Tape
Paper Installation
Templates (Pages 4 - 7)
GREEN LINE.
Figure B
SUBARU OF AMERICA
*Vaughan 12 oz.
Rubber Mallet
(or any 12 oz. Rubber Mallet)
: TOOLS & EQUIPMENT - Specific Tools
and equipment recommended for this
process.
ADJUSTING
Figure C
PAGE
Nylon
Removal
Tool
1/7