Publicité
Les langues disponibles
Les langues disponibles
Installation
Frame and Bowl Assembly
2
When installed properly, the basin will be level and flush to the back wall.
For clarity, the pre-mounted soap spout, faucet spout,
dryer hood and air hoses are not shown.
Position the basin
onto the frame. The
A
right vertical frame
support will fit into
the basin notch as
shown.
Use the back
basin flange
as a template
to mark the (2)
mounting hole
locations onto
the wall. After
marking the wall,
install suitable
wall anchors. See
step 1b.
Drain and P-Trap
3
D
Use ⁵⁄₆₄" hex driver to
install screw to drain
cap assembly.
Drain Cap Assembly
(S45-2714)
Assembly o-ring, drain
B
adapter and packing
washer to basin hub
with (4) #10 screws.
Do not overtighten the
screws on the drain adapter!
Bradley • 215-1771 Rev. K: ECO 21-08-042
O-Ring
(125-111)
Packing Washer
(142-135)
#10 Screw
P10-225
P-trap
For clarity, the soap spout, faucet spout, dryer
hood and frame are not shown.
Drain Adapter
(111-091)
P-Trap Outlet
C
Attach p-trap to
outlet and drain.
12/31/2021
Secure the basin flange
B
to the back wall using
suitable
" fasteners
³⁄₈
supplied by the installer.
Access the basin
flange through the
dryer hood access
hole. See Step 5 for
more information on
how to remove dryer
hood cover and how
to disconnect the
upper plenum hoses
for access to the
basin flange.
Secure the bowl to the
C
frame with the two ¼"-20
x
" screws (p/n 160-
³⁄₈
389) and washers (p/n
142-002DB) provided.
A
Install p-trap outlet to
stub out from wall.
AV30
11
Publicité
