Publicité
Les langues disponibles
Les langues disponibles
(2) OPERATION OF CONTROLS
The hood is operated using the electronic switch on the front panel.
The power switch turns the range hood on and off.
The light switch turns the lamps on and off.
The blower switch turns the blower on to four speed settings.
Low speed show F1
Medium speed shows F2
High speed shows FC3
Booster shows P
The timer delay switch decides how long the hood stays on after switching
off.
Grease Filters
The grease filters should be cleaned frequently. Use a warm detergent
solution. Grease filters are washable.
See "INSTALL FILTERS" section for removal and installation instructions.
Non-Ducted Recirculation charcoal filter
The non-ducted recirculation charcoal filter should be changed every 6
months.
See "INSTALL FILTERS" section for removal and installation instructions.
INSTALL THE DUCTWORK
(DUCTED HOODS ONLY)
Caution: To reduce the risk of fire, use metal
ductwork is preferred.
1. Decide where the ductwork will run
between the hood and the outside.
2. A straight, short duct run will allow the
hood to perform most efficiently.
3. Long duct runs, elbows, and transitions
6
Publicité
