Publicité
Les langues disponibles
Les langues disponibles
screws and dry wall anchors. Align the hood body with the hood
mounting bracket. Gently lower the hood until it securely engages the
bracket.
2. Fix the discharge collar into the air outlet adapter.
3. Attach an adequate length of 150mm round duct to the air outlet
adapter.
4. Carefully slide the decorative chimney top down inside the decorative
chimney bottom. Carefully place the decorative chimney bottom into the
recessed area of the hood body top.
5. Secure the chimney mounting bracket to the wall using (2) ST 5 x
45mm mounting screws and dry wall anchors.
6. Raise the decorative chimney top until its holes align with holes in the
chimney mounting bracket (located on the wall).
7. Level the hood and secure the chimney with 2 chimney bracket screws.
8. Fix the hood body with two screws from inside of body.
ST5*50
INSTALL FILTERS
1. To remove the grease filter, push in on the metal latch tab. This will
disengage the filter from the hood. Tilt the filter downward and remove.
2. To install the grease filter, align rear filter tabs with slots in the hood.
Push in the metal latch tab, push filter into position and release. Make
sure the filter is securely engaged after assembly.
Discharge Collar
Hood Mounting
Bracket
Air outlet Adapter
Hood Body
Duct
8
Chimney Mounting
Bracket
Decorative
Chimney
Top
Decorative
Chimney
Bottom
Publicité
