Makita HS300D Manuel D'instructions page 5

ENGLISH (Original instructions)
1. Battery cartridge
2. Button
3. Clamping screw
4. Depth guide
5. Bevel scale plate
6. Cutting line
SPECIFICATIONS
Blade diameter
Max. Cutting depth
No load speed (min
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2014
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
• Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may
cause injury and/or fire.
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Explanation of general view
7. Lock-off lever
8. Switch trigger
9. Shaft lock
10. Hex wrench
11. Hex bolt
12. Outer flange
Model
at 90°
at 45°
-1
)
Net weight
BL1013 / BL1015K
CORDLESS CIRCULAR SAW
ENE028-1
SAFETY WARNINGS
Cutting procedures
1. DANGER: Keep hands away from cutting area
and the blade. Keep your second hand on
auxiliary handle, or motor housing. If both hands
GEA010-2
are holding the saw, they cannot be cut by the blade.
2. Do not reach underneath the workpiece. The guard
cannot protect you from the blade below the
workpiece.
3. Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade teeth
should be visible below the workpiece.
4. Never hold the workpiece in your hands or across
your leg while cutting. Secure the workpiece to a
stable platform. It is important to support the work
properly to minimise body exposure, blade binding, or
loss of control. (Fig. 1)
5. Hold the power tool by insulated gripping
surfaces, when performing an operation where the
cutting tool may contact hidden wiring or its own
cord. Contact with a "live" wire will also make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
13. Saw blade
14. Inner flange
15. Protrusion
16. Protrusion (bigger side)
17. Dust nozzle (accessory)
18. Screw
HS300D
85 mm
25.5 mm
16.5 mm
1,400
300 mm
1.5 kg
D.C. 10.8 V
DC10WA
GEB151-1
5