Black & Decker BCF602 Mode D'emploi page 6

ENGLISH
Always hold the tool and screwdriver bit in a straight line
u
with the screw.
When screwing in wood, it is recommended to drill a
u
pilot hole with a depth equal to the length of the screw.
A pilot hole guides the screw and prevents splintering or
distortion of the wood. For the optimum size of the pilot
hole, refer to the table below.
When screwing in hardwood, also drill a clearance hole
u
with a depth equal to half the length of the screw. For
the optimum size of the clearance hole, refer to the table
below.
Screw size Pilot hole Ø
(soft wood)
No. 6 (3.5mm) 2.0mm
No. 8 (4mm) 3.2mm
No. 10 (5mm) 3.5mm
Maintenance
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
Warning! Before performing any maintenance on the tool,
unplug the charger before cleaning it.
Regularly clean the ventilation slots in your tool and
u
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
not use any abrasive or solvent-based cleaner.
Regularly tap bit holder to remove any dust from the
u
interior.
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical Data
Voltage V
DC
No-load speed Min
6
(Original instructions)
Pilot hole Ø Clearance hole
(hard wood)
2.5mm
3.5mm
4mm
BCF602
-1
Max. torque
(PTI Rating)
Battery Type
Battery capacity
Weight
Charger
Input Voltage
Output Voltage
4mm
Current
5mm
5.7mm
Approx. charge time
Level of sound pressure according to EN 62841:
Sound pressure (L
Sound power (L
Vibration total values (triax vector sum) according to EN 62841:
Screwdriving without impact (a
EC declaration of conformity
Black & Decker declares that these products described under
"technical data" are in compliance with:
2006/42/EC, EN62841-1:2015, EN62841-2-2:2014.
These products also comply with Directive 2014/30/EU and
2011/65/EU. For more information, please contact Black &
Decker at the following address or refer to the back of the
3.6
180
Nm
Ah
kg
V
AC
V
DC
mA
Hours
) 52.5 dB(A), uncertainty (K) 3 dB(A)
pA
) 63.5 dB(A), uncertainty (K) 3 dB(A)
WA
2
) 0.5 m/s , uncertainty (K) 1.5 m/s
h
%
MACHINERY DIRECTIVE
BCF602 - Screwdriver
manual.
BCF602
5.5
Li-Ion
1.5
0.3
S010Q-14
100 - 240
14
400
4
2