Media Player - Oceanic OCEALED40120B2 Guide D'utilisation

Media Player

Before operating MEDIA menu, plug in USB device, then press SOURCE button to set
the input source to Media.
Press ◄/► button to highlight your preferred submenu: Photo, Music, Movie and e-Book,
press OK button to confirm.
Basic operation for photo, music and movie:
1) RED: Delete highlighted files.
2) GREEN: Add/remove all the files to play list
3) OK: Add/remove highlighted file from play list.
4) CH+/-: Page up/down
5) Press ► button to start playing.
Remark: Depending on the capacity of the device, the reading can take more than 1
minute before launching the video.
The unit cannot read my USB device.
- Once you have plugged your device to the unit, you may need to switch on the USB
device before it can operate.
- This unit does not support a direct USB connection with a computer. You need to use
a USB device, a MP3 player or a PMP (Portable Multimedia Player with hard disk).
If you are using a USB external hard disk: you need to connect your device.
-
simultaneously to an external power source and to the unit. If you are using a
self-powered PMP, make sure that the battery is sufficiently loaded.
Check that the files system of your USB device is formatted into the FAT 32 format.
-
USB device formatted into NTFS are not compatible with this unit. Caution: if you
attempt to modify your file system, formatting your device will erase all data. Please
refer to your USB device's instruction manual first.
- Warning: Connect your USB device directly to the USB port of the device. Using an
extension cable is not recommended and may cause interference and failure of data
transfer.
EN-35