Oceanic OCEALED40120B2 Guide D'utilisation page 80

HDMI LINK
Press ▲/▼ button to select HDMI Link, then press OK button or ► button to enter.
Before using "HDMI Link" function:
- Make sure the HDMI device (Amplifier, etc.) is connected correctly and HDMI device
must support HDMI CEC (Consumer Electronics Control).
- Press SOURCE button on the remote control to select HDMI input source.
Enable HDMI Link
Turn on/off HDMI Link.
Auto Power on
Turn on/off Auto Power On. If turned on, this TV will turn on automatically when you turn
on the CEC enabled external device.
Auto Standby
Turn on/off Auto Standby function. If turned on, the CEC enabled external device will
enter standby mode when you turn this TV to standby mode.
Speaker Preference
Select TV Speakers or Amplifier as a preference when external ARC enabled amplifier is
connected.
Amplifier Support ARC (in HDMI 3 only)
Turn on/off ARC function. If this function is enabled, you can use an external amplifier or
audio decoding device which supports ARC .
EN-33