Hilti SF 6-A22 Mode D'emploi page 17

5.2 Removing the battery
1. Press the battery release buttons.
2. Remove the battery from the tool.
5.3 Charging the battery
1. Before charging the battery, read the operating instructions for the
charger.
2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery.
5.4 Installing the side handle
CAUTION
Risk of injury! Loss of control over the rotary hammer drill.
▶ Check that the side handle is fitted correctly and tightened securely. Make
sure that the clamps are correctly seated in the grooves provided for the
purpose.
1. Move the forward/reverse switch into the middle position.
2. Turn the grip to release the clamps of the side handle.
3. Seat the side handle clamping band fully on the housing and push the
clamps into the grooves provided for the purpose.
4. Turn the grip to tension the clamps of the side handle.
5.5 Fitting the belt hook (optional)
WARNING
Risk of injury. A falling power tool may present a risk of injury to yourself
and others.
▶ Check that the belt hook is fitted securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by
the operator. The belt hook can be fitted to allow attachment on the left
or right side of the body.
1. Remove the battery. → page 11
2. Insert the belt hook into the opening provided at the base of the product.
3. Secure the belt hook with the two screws.
4. Insert the battery. → page 10
5.6 Installing Hilti bit holder (optional)
1. Remove the battery. → page 11
2. Insert the bit holder into either the left or right opening provided at the
base of the product.
*2231427*
Printed: 19.08.2019 | Doc-Nr: PUB / 5467429 / 000 / 01
2
3
2231427
4
English 11