Publicité
Les langues disponibles
Les langues disponibles
The figure below provides an example of the placing of
a built-in fireplace in a hearth constructed in accord-
ance with the above instructions.
A
Flue
B
Seal
C
Cover plate
D
Insulation 10 cm
Fireproof wall, min 10cm (e.g. cellular con-
E
crete)
F
Combustible wall
G
Convection space
H
Fireproof ceiling
I
Combustible ceiling
J
Convection air outlet
K
Insulation
M
Combustible floor
N
Opening to prevent pressure build-up
O
Connection pipe
18
Place finishing cover
1. Place the four supplied magnets (2) on the side of
the frame; see following figure.
2
1
2. Slide the supplied cover (1) into the frame.
Finishing
1. Re-position all removed parts in the correct places
in the appliance.
2. Ensure that the newly built hearth is sufficiently
dry before you start to use the appliance.
Never use the appliance without the fire-res-
istant inner plates.
The appliance is now ready for use.
Use
First use
When you use the appliance for the first time, make
an intense fire and keep it going for a good few hours.
This will cure the heat-resistant paint finish. This may
result in some smoke and odours. You could open win-
dows and doors for a while in the area in which the
appliance is located.
Fuel
This appliance is only suitable for burning natural
wood; sawn and chopped wood that is sufficiently dry.
Do not use other fuels, as they can cause serious
damage to the appliance.
Subject to change because of technical improvements
09-20021-132
Publicité
