Hilti Nuron SF 6H-22 Mode D'emploi page 20

2. Remove the battery from the product.
5.4 Installing the side handle
CAUTION
Risk of injury! Loss of control over the rotary hammer drill.
▶ Check that the side handle is fitted correctly and tightened securely.
Make sure that the clamps are correctly seated in the grooves provided
for the purpose.
1. Turn the grip to release the clamps of the side handle.
2. Seat the side handle clamping band fully on the housing and push the
clamps into the grooves provided for the purpose.
3. Turn the grip to tension the clamps of the side handle.
5.5 Inserting the accessory tool
1. Open the keyless chuck.
2. Insert the accessory tool into the tool holder.
3. Tighten the keyless chuck.
4. Check that the accessory tool is held securely.
5.6 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether
for possible damage.
▶ Do not secure a tool tether to the belt hook. Do not use a belt hook to lift
the product.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining
strap #2293133 and the Hilti tool tether #2261970.
▶ Secure the retaining strap to the installation openings for accessories.
Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure
the second carabiner to a load-bearing structure. Check that both
carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap
and those of the Hilti tool tether.
14 English
2
3
2275218
*2275218*