Hilti Nuron SF 6H-22 Mode D'emploi page 15

▶ If the battery is too hot to touch, it may be defective. Put the battery
in a place where it is clearly visible and where there is no risk of fire,
at an adequate distance from flammable materials. Allow the battery
to cool down. If it is still too hot to touch after an hour, the battery is
faulty. Consult Hilti Service or read the document entitled "Instructions
on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage
and use of lithium-ion batteries. → page 17
Read the instructions on safety and use of Hilti Li-ion batteries
that you can access by scanning the QR code at the end of these
operating instructions.
3 Description
3.1 Product overview
Keyless chuck
@
Torque and operating mode
;
selector ring
Side handle
=
Gear selector switch
%
Forward/reverse switch with
&
transport lock
Control switch with electronic
(
speed control
3.2 Intended use
The product described is a hand-held cordless drill/driver. It is designed for
drilling in steel, wood, plastic, cellular concrete and masonry and for driving
and removing screws.
• For this product, use only Hilti Nuron lithium­ion batteries of the B 22
series. For optimum performance, Hilti recommends the batteries stated
in the table at the end of these operating instructions for this product.
• For these batteries, use only Hilti chargers of the type series stated in
the table at the end of these operating instructions.
3.3 ATC
The product is equipped with the ATC (Active Torque Control) quick-acting
electronic cut-out.
If the accessory tool sticks or stalls, the product will suddenly pivot about
its own axis in the opposite direction. ATC detects this sudden pivoting
movement of the product and switches the product off immediately.
*2275218*
1
)
+
§
/
:
∙
2275218
Grip
Work-area light (LED)
Installation opening for acces-
sories
Battery
Release button, battery
Battery status indicator
English 9