Publicité
Les langues disponibles
Les langues disponibles
26
Change and clean the spark plug
1. Once the engine has cooled, remove the spark plug
using the spark plug wrench supplied.
2. Clean the plug with a wire brush.
3. Using a feeler gauge; set the gap to 0.6-0.7 mm (see
fig.27 & 28).
4. Install the spark plug carefully by hand, to avoid
cross-threading.
5. After the spark plug is seated, tighten with spark plug
wrench to compress the washer.
27
GB | Operating Instructions
28
Clean the air filter
Unclip the air filter cover and remove the sponge filter
element. To avoid objects falling into the air tank, replace
the air filter cover. Wash the filter element in warm soap
water, rinse and allow drying naturally.
Warning! Never run the engine without the air filter
element installed.
12
Publicité
