Publicité
Les langues disponibles
Les langues disponibles
Vario speed adjustment
With the Vario gearbox, the driving speed of the lawn
mower can be variably adjusted.
WARNING: Operate the lever only when the motor
is running. Switching without motor drive can
damage the drive mechanism.
• For higher speed, pull the lever in direction A
• For lower speed, pull the lever in direction B
Always adapt the driving speed to the current ground
and grass condition.
18
Stopping the mower
To stop the mower, release the operator control lever.
The engine and the blade will stop turning automatically.
If there is a build-up of grass beneath the chassis, stop
the engine, remove the spark plug cap and wait until the
engine has cooled before clearing the grass.
When the engine has been switched off, the cutter
continues running for several seconds therefore do
not touch the underside of the mower until the cutter
has come to a standstill!
Mulching insert
The mulching insert prevents grass from being collected
by blocking the collection chute. This allows the grass
clippings to be deposited back on the lawn during cutting.
19
GB | Operating Instructions
1. Open the rear deflector guard, hold it in position and
20
2. Press the lower side of the handle to release and
3. When removing the mulching insert, you should drag
Side ejector with locking lever
Use the side discharge attachment when using the prod-
uct for side discharging.
21
Locking lever
1. Before you use the side ejector, press the end of the
22
10
insert the mulching insert into the rear discharge
chute (Fig. 19). Ensure the lower side of the handle
snaps in place.
remove the mulching insert (Fig. 20).
it to the left side and remove it from the mower deck.
locking lever down to unlock the side ejector cover
(see fig. 21 and 22).
1
Publicité
