Braun 7880cc Mode D'emploi page 12

Replacing the cleaning cartridge
After having pressed the lift button (2) to open the housing, wait for a few seconds
before removing the used cartridge to avoid any dripping. Before discarding the used
cartridge, make sure to close the openings using the lid of the new cartridge, since the
used cartridge will contain contaminated cleaning solution.
Keeping your shaver in top shape
Replacing the Foil & Cutter cassette / reset
To maintain 100% shaving performance, replace the Foil & Cutter cassette (8), when
the replacement symbol (16c) lights up on the shaver display (after about 18 months)
or when cassette is worn. The replacement symbol will remind you during the next
7 shaves to replace the Foil & Cutter cassette. Then the shaver will automatically reset
the display.
After you have replaced the Foil & Cutter cassette, use a ball-pen to push the reset
button (15) for at least 3 seconds to reset the counter. While doing so, the replacement
light blinks and goes off when the reset is complete. The manual reset can be done at
any time.
Accessories
Available at your dealer or Braun Service Centres:
• Foil & Cutter cassette 70S
• Cleaning cartridge Clean&Renew CCR
Battery removal
This appliance contains a rechargeable battery. Before disposing of the appliance,
disassemble the housing as shown, remove the rechargeable battery and recycle or
dispose of properly, according to local guidelines.
Caution: Disassembling the appliance will destroy it and invalidate the warranty.
1.
The cleaning cartridge can be disposed of with regular household waste.
Subject to change without notice.
For electric specifications, see printing on the special cord set.
12
2. 3.
4.
Li-Ion