Hoover HDIN4D620PB Mode D'emploi page 99

15. PROGRAMME SELECTION
AND SPECIAL FEATURES
ON/OFF button
To turn the appliance on and off, press

the ON/OFF button (for at least 3 seconds).
At the end of the cycle, remember to
switch off the appliance using the
ON/OFF button, then remove the plug
and close the water supply.
First time you switch on the
appliance
Connect the machine to the power supply.

Open the door, put the dishes to be

washed inside, and close the door again.
Press the "ON/OFF" button and hold for

about 3 seconds.
In this phase only the "OPEN DOOR/

EXPRESS" "EXTRA DRY" and "START/
RESET" buttons will remain active. The
message "H-DISH 500" will appear on
the display and all the indicator lights will
turn on for 3 secs.
The message "ENGLISH" will appear on

the display.
Pressing the "OPEN DOOR/EXPRESS"

and "EXTRA DRY" buttons you can
select the preferred language.
To accept the language selection press

the "START/RESET" button Immediately
afterwards the "WELCOME" message
will scroll on the display once and the
indicator lights will all be off.
"ECO" will appear on the display.

Press "START/RESET" and a signal will

sound, the indicator light corresponding to
the selected programme will stay on and
the wash indicator light will come on.
Close the door (after an audible signal

has sounded, the programme will start
automatically).
WARNING
In the event that the machine remains
switched on without selecting or
starting any program, after 5 mins. the
dishwasher will switch off automatically.
Next time you switch on the
appliance
Open the door.

Hold down the ON/OFF button for about 3

secs to turn the machine on and the
"ECO" programme or the programme
you have decided to use will appear on
the display, saving it when the dishwasher is
switched on. (To save the programme,
see the specific paragraph "Memorising
the last programme used").
Settings Menu
The dishwasher is regulated with certain
factory settings. Nevertheless, from the
Settings menu, you can adjust various
parameters to suit your washing requirements.
Entering the Settings menu
The dishwasher must ALWAYS be off
before you start this procedure.
Open the door.

Turn on the dishwasher by holding the

"ON/OFF" button down for about 3 secs.
Hold down the "PROGRAMME SELECTION"

and "ON/OFF" buttons for about 5 secs.
The message "SETTINGS" will appear

on the display and the indicator lights of
the "OPEN
"EXTRA DRY" buttons will be on.
Pressing the "PROGRAMME SELECTION"

button you can select the parameters to
be adjusted in succession (SOFTENER
→ BUZZER → MEMO FUNCTION).
Parameter adjustment is performed by

pressing the "OPEN DOOR/EXPRESS"
and "EXTRA DRY" buttons.
99
DOOR/EXPRESS" and