Télécharger Imprimer la page

Hoover HDIN4D620PB Mode D'emploi page 103

Publicité

Les langues disponibles

Les langues disponibles

If the delayed start is not confirmed by
pressing the "START/RESET" button,
after approx. 10 sec. the delayed start
will be cancelled.
(Only for free-standing models)
The length of the selected cycle will
be shown on the display. At the end of
the countdown, the programme will
automatically start and the length of
the selected cycle will be shown on
the display.
Proceed as follows to cancel a delayed
start:
Hold the "START/RESET" button down
for at least 3 seconds. "00" will appear on
the display "RESET" and audible signals
will sound.
The delayed start and the selected
programme
will
dashes will appear on the display.
At this point, to set off the dishwasher, a
new programme and any option buttons
must be selected, as indicated in the
"PROGRAMME SETTINGS" paragraph.
Activation/Muted END-OF-
PROGRAMME signal.
You can deactivate turning on and off of the
audio signal as follows (the default setting is
active):
The dishwasher must ALWAYS be off
before you start this procedure.
Open the door.
Turn on the dishwasher by holding the
"ON/OFF" button down for about 3 secs.
Hold down the "PROGRAMME SELECTION"
and "ON/OFF" buttons for about 5 secs.
The message "SETTINGS" will appear
on the display and the indicator lights of
the
"OPEN
DOOR/EXPRESS"
"EXTRA DRY" buttons will be on.
be
cancelled.
Two
and
Pressing the "PROGRAMME SELECTION"
button until the "BUZZER" parameter is
selected.
Parameter adjustment is performed by
pressing the "OPEN DOOR/EXPRESS"
and "EXTRA DRY" buttons to change the
value from YES to NO and vice versa.
Switch off the dishwasher by pressing the
"ON/OFF" button for 3 secs to confirm
the new setting.
To turn the alarm on again, follow the same
procedure.
MEMO FUNCTION (Memorising
the last programme used)
The dishwasher must ALWAYS be off
before you start this procedure.
Open the door.
Turn on the dishwasher by holding the
"ON/OFF" button down for about 3 secs.
Hold down the "PROGRAMME SELECTION"
and "ON/OFF" buttons for about 5 secs.
The message "SETTINGS" will appear
on the display and the indicator lights of
the
"OPEN
"EXTRA DRY" buttons will be on.
Pressing the "PROGRAMME SELECTION"
button until the "MEMO FUNCTION"
parameter is selected.
Parameter adjustment is performed by
pressing the "OPEN DOOR/EXPRESS"
and "EXTRA DRY" buttons to change the
value from
"MEMO MODE OFF" and vice versa.
Switch off the dishwasher by pressing the
"ON/OFF" button for 3 secs to confirm
the new setting.
To turn the alarm on again, follow the same
procedure.
103
DOOR/EXPRESS"
"MEMO MODE ON" to
and

Publicité

loading