"OPEN DOOR" button "
(AUTOMATIC DOOR OPENING)
(only on some models).
This option enables a special device that
opens the door by a few centimetres during
or at the end of the drying cycle (depending
on the programme). This ensures the natural
and efficient drying of dishes. The duration of
the selected cycle will automatically change to
obtain the optimal temperature for the rinse
cycle; this significantly reduces energy
consumption. The automatic door opening
during the last drying phase enables the air to
circulate, removing the risk of bad odours.
When the door opens, the message "OPEN
DOOR" will appear on the display.
This option is automatically enabled
in the "ECO" programme. In any case,
it is possible to disable it. The "OPEN
DOOR" feature is not available in the
"RAPID 29'", "RAPID 39'" and "PREWASH"
programmes.
WARNING
With this option selected, you must
not in any way prevent the door from
opening or force it shut, as this would
damage the mechanism. Ensure that
there is free space in front of the door
and, before closing, wait for the
opening device to complete its activity.
"EXTRA DRY"
button
(only on some models).
This option allows you to achieve the
highest efficiency in drying, increasing the
wash water temperature during the last
phase of the wash cycle.
"NO SALT" warning light
If your dishwasher requires salt, "SALT"
will be displayed when selecting the
programme. The appearance of whitish
stains on dishes is generally a warning sign
that the salt container needs filling.
In order to guarantee the correct
functioning of the salt indicator light,
YOU MUST ALWAYS FULLY REPLENISH
THE SALT CONTAINER.
"DELAY START" button
Dishwasher start time can be set with this
button, delaying start from 1 to 23 hours.
Proceed as follows to set a delayed start:
Open the door.
Turn on the dishwasher by pressing the
"ON/OFF" button for about 3 sec.
Select the washing programme.
Press the
"DELAY START"
("0:30" will appear on the display).
Press the button again to increase the
delay (on each press the delay is
increased by 30 mins., up to a maximum
of 23:30.
When the delay is set on a programme:
- after pressing "START/RESET", the
countdown time "00:00" appears on the
display with flashing " : "
- if you press any button (except for the
"ON/OFF", "PROGRAMME SELECTION"
buttons), the programme name is
displayed for a single scroll on the
display and then the delay time is
displayed again.
- When the time has elapsed, the programme
name is displayed for a single scroll on
the display and the remaining time will
be displayed as "0:00h".
To start the countdown, press the
START/RESET button. The display will
show the time remaining to the end of the
programme. At the end of the countdown,
the programme will start automatically.
102
button