19. TROUBLESHOOTING AND WARRANTY
If you believe the dishwasher is not working correctly, consult the quick guide provided
below with some practical tips on how to fix the most common problems. If the
malfunction continues or recurs, contact the Technical Assistance Centre.
BUG REPORTS
Models with a display: errors are reported by a number preceded by the letter "E"
(e.g. Error 2 = E2) and a short audio signal.
Models without a display: an error is shown by a sequence of flashes of every LED.
The error code is shown by the number of flashes followed by a pause of 5 seconds
(example: two flashes – pause 5 seconds – two flashes – repeating = Error 2).
Only models with a display
Error displayed
"CHECK WATER"
with a short audio signal
(only on some models).
E2
(with display) with a
short audio signal
E3
(with display) with a
short audio signal
E4
(with display) with a
short audio signal
E8-Ei
(with
display)
with a short audio signal
Any other code
(with display)
Meaning and solutions
The dishwasher does not fill with water
Make sure the water supply is open.
Make sure the water supply hose is not bent or crushed.
Make sure the drain pipe is at the proper height (see installation
section).
Close the water supply, unscrew the drain pipe from the back of the
dishwasher and check that the "sand" filter is not clogged.
The dishwasher does not drain water
Make sure the drain pipe isn't bent, trapped or blocked, and the filter
is not clogged.
Make sure the siphon is not clogged.
Water leak
Make sure the drain pipe isn't bent, trapped or blocked, and the filter
is not clogged.
Make sure the siphon is not clogged.
The water heating element is not working correctly or the filter
plate is clogged
Clean the filter plate.
Turn off and unplug the dishwasher, wait a minute. Turn on the
machine and restart a program. If the error occurs again contact an
Authorised Customer Service Centre directly.
110