noken Bela 100114968 Installation Et Maintien page 5

MAINTENANCE
BRASSWARE AND ACCESSORIES
First of all we thank you for buying our products which are manufactured to the highest standards.
However in common with other products our brassware requires the correct cleaning and periodic
maintenance.
CLEANING
To clean brassware and accessories please note the following recommendations.
- For regular cleaning only use warm soapy water, if this is not possible use soft non abrasive gels or
similar cleaning products, rinse thoroughly and polish with a soft cloth.
- Please avoid the use of harsh or abrasive products such as scouring powders, those products with
phosphoric acid, hydrochloric acid, formic acid or acetic acid that could badly damage the product.
Please only use PH neutral products.
- Dry the items after each cleaning sesion and after every use to avoid limestone appearance.
WARNING
- Cleaning materials will only worsen already damage product.
- Do not mix cleaning products, the chemical reactions can emit toxic fumes and react badly with
product surfaces.
- Do not use harsh or abrasive cloths, pads or cleaning products.
- Do not use bleach or other chlorine based cleaning products.
- Only use suitable cleaning products as recommended for each product he cleaning products only
make worse the surfaces if those are already damages.
RECOMENDATIONS FOR THE CLEANING AND PRESERVATION OF BRASSWARE AND
ACCESSORIES
- Read the manufacturers instructions.
- To protect the brassware, internal mechanism and to extend the life of the product it is recommended
in line with "best practice" to install isolation valves and in line fi lters.
- Regular cleaning to reduce lime scale and soap residue build up.
- Do not leave these products in contact with the product surface longer than the manufacturer's
recommendations and rinse thoroughly with clean water.
- Do not spray cleaning products directly onto the product surface, spray onto a soft cloth and then
apply to the product. Spraying directly onto the product can lead to cleaning fl uids being drawn into
the products through capillary action causing irreversible damage.
- If a tap is left dripping it may lead to staining and lime scale build up. Please ensure taps are
correctly turned off after use.
GUARANTEE CLAUSE
- Failure to comply with the maintenance instructions may invalidate the guarantee.
8
INSTALACIÓN_INSTALLATION_INSTALLATION
Conexión a la red G1/2" hembra - Water connection G 1/2" female - Connexion au réseau hydraulique
G1/2" Femelle
OK! OK!
usar cáñamo o teflon
use hemp or teflon
employer chanvre ou teflon
CARACTERÍSTICAS TÉCNICAS_TECNHICAL DATA_CARACTÉRISTIQUES TECHNIQUES
Rango de trabajo 0.5 bar Working pressure
Presión óptima 3 bar* Optimal pressure
Presión máxima 5 bar Maximum pressure
Temperatura máxima 70 ºC
Temperatura máxima 70 ºC
Material Latón
Material
0,3 μm
cromo
Micraje
Coating
10 μm
niquel
* Recomendamos instalar válvulas reductoras de présion para presiones superiores
* We recommend the installation of the pressure valves where the high pressure is present
* Nous vous recommandons l'installatión de valves réductrices de préssion pour des préssions supérieures
Respetar la medida de instalación
marcada en el dibujo.
NO!
Comply with the installation size re-
ported in the drawing.
Respecter la mesure d'installation
indiquée dans le dessin.
0.5 bar Rang de préssion
3 bar* Préssion optimale
5 bar Préssion maximale
Temperatura máxima 70 ºC
Brass Material
0,3 μm
chorme
chrome
Micrometrie
10 μm
nickel
nickel
0.5 bar
3 bar*
5 bar
Laiton
0,3 μm
10 μm
5