Philips LatteGo 3200 Seire Mode D'emploi page 22

English
22
Icon Solution
The alarm light is on
-
-
The alarm light is flashing
-
-
The alarm light is on and the start light flashes.
Some air is trapped inside the machine. To release the air from the machine, fill the
water tank with water, place a cup under the classic milk frother and press the
flashing start/stop button.
Be careful: small jets of hot water will be dispensed from the classic milk frother to
release the air.
AquaClean light is flashing: place or replace the AquaClean water filter and activate
it. See chapter 'AquaClean water filter' for step-by-step instructions.
Descaling light is flashing slowly: Descale the machine (see 'Descaling procedure (30
min.)').
The lights in the drink icons light up and go out one by one.
The machine is heating up and/or trying to release the air that was drawn into the
machine. Wait until all drink lights light up continuously.
The lights of all warning icons are flashing.
Reset the machine by unplugging it and plugging it back in. Before switching the
machine back on, follow these steps:
-
-
-
-
If the problem is not solved, the AquaClean filter was not prepared properly. Prepare
the AquaClean filter before placing it back by following steps 1 and 2 in chapter
'Activating the AquaClean water filter (5 min) '.
If the lights continue to flash, the machine could be overheated. Switch off the
machine, wait 30 minutes and switch it on again. If the lights are still flashing, contact
the Consumer Care Center in your country. For contact details, see the international
warranty leaflet.
The coffee grounds container and/or the drip tray is not in place or not placed
correctly. Place back the coffee grounds container and/or the drip tray and make
sure they are in the correct position.
The service door is open. Remove the water tank and make sure the service door
is closed.
The brew group is not in place or not placed correctly. Remove the brew group
and make sure it is locked into place. See chapter 'Removing and inserting the
brew group' for step-by-step instructions.
The brew group is blocked. Remove the brew group and rinse it with water under
the tap. Then lubricate the brew group and place it back into the machine. See
chapter 'Cleaning and maintenance' for step-by-step instructions.
Remove the AquaClean water filter from the water tank.
Place back the water tank. Push it into the machine as far as possible to make
sure it is in the right position.
Open the lid of the pre-ground coffee compartment and check if it is clogged
with coffee powder. To clean it, insert a spoon handle into the pre-ground coffee
compartment and move the handle up and down until the clogged ground
coffee falls down (Fig. 27). Remove the brew group and remove all ground coffee
that has fallen down. Place back the clean brew group.
Switch the machine back on.