Indesit SAN 400 Mode D'emploi page 11

Stability bracket
(Models SAN400 and SAN400S only):
WARNING: To prevent the fridge from tilting forwards, it
must be held in place with the stability bracket supplied.
This is the responsibility of the customer.
Fixed to the floor or wall at the rear of the fridge, the
stability bracket hooks onto the compressor mounting
plate holding the fridge secure.
The stability bracket must be installed securely in
accordance with these instructions BEFORE using
the fridge.
Note: The fridge is heavy so care must be taken when
moving it.
1. Position the fridge in its chosen location.
2. Looking from the front of the fridge, mark the position
of the left hand panel.
3. Move the fridge far enough away to get clear access
to the back wall.
4. In order to clear components on the compressor
mounting plate, the stability bracket must be
positioned on the floor between 100 - 200mm to the
right of the left hand panel mark.
5. Mark and drill the fixing holes and insert suitable
fixings to hold the bracket firm.
6. Carefully re-position the fridge. Make sure that the
compressor mounting plate locates into the stability
bracket.
Position stability racket
100 - 200mm away from left
hand panel mark.
Position of left Position of left Position of left
Position of left Position of left
hand panel hand panel hand panel hand panel hand panel
GB
11