Publicité
Electrical connections
Ovens equipped with a three-pole power cable are designed to operate on alternating
current. The earth wire of the appliance is yellow-green.
Installing the power cable Fig. 5
-
Opening the terminal board:
-
Take a screwdriver.
-
Unscrew the screws on the side tabs of the cover and remove the latter.
To install the power cable, proceed as follows:
-
Remove the cable retaining screw and the three contact screws. (L-N).
-
Fix the wires under the screw heads using the following colour scheme: Blue (N) Brown
(L) Yellow-Green.
-
Secure the power cable with the cable clamp and close the terminal board cover.
Connecting the power cable to the mains
-
Install a standard plug socket corresponding to the load indicated on the rating plate.
When connecting the cable directly to the mains, install an omnipolar circuit breaker
with a minimum contact opening of 3 mm between the appliance and the mains. The
omnipolar circuit breaker must be sized according to the load and comply with the
applicable regulations (the earth wire must not be interrupted by the circuit breaker).
Position the power cable in such a way as to prevent it from reaching 50 ℃ above
-
ambient temperature at any point along its length, and make sure it's protected by
insulation with an appropriate rating.
Before connecting, check the following:
The electrical safety of this appliance can only be guaranteed if the oven is correctly and
-
effectively earthed in accordance with electrical safety regulations. Always make sure
that the ground connection is effective; if in doubt, call a qualified technician to check the
system. The manufacturer declines all liability for damage resulting from an ungrounded
system.
Before connecting the appliance to the mains, check that the specifications indicated on
-
the rating plate (on the appliance and/or on the packaging) correspond to those of the
mains supply at home.
Check that the electrical capacity of the installation and the sockets can withstand the
-
maximum power of the appliance. If in doubt, contact a qualified technician.
If the socket and plug of the appliance are not compatible, ask a qualified technician
-
to replace the socket with a suitable model. The latter, in particular, will also have to
ensure that the cross-section of the socket cables is adequate for the power used by the
appliance. The use of adapters, multiple sockets and/or extensions is not recommended.
If their use cannot be avoided, remember to use only single or multiple adapters and
extension cords that comply with current safety regulations. In these cases, never exceed
H O R N O B O L E R O H E X A M 2 2 6 0 0 0 I N OX A / E D G E A / M AT T A / G L A S S B L AC K / W H I T E A / G R E Y A
ENGLISH
53
Publicité
