Publicité
ENGLISH
-
Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
-
Rack
-
Grease-collection tray
-
Wire rack
-
Baking tray
-
Instruction manual
3. INSTALLATION
To install the appliance, refer only to qualified professionals. The manufacturer declines all
liability in the event of incorrect installation and subsequent injury to people and animals, as
well as damage to property.
Important
Unplug the appliance from the mains before any adjustment or maintenance work is
-
carried out.
The air duct is used for ventilation.
-
Built-in installation
To ensure the correct operation of the appliance, make sure the piece of furniture is suitable
for built-in installation. Figure 3 shows the adequate size of the hole for installation under a
worktop or in a wall unit.
Installation in accordance with the statement of consumption
To ensure adequate ventilation, the rear panel of the cabinet must be removed. It is
-
preferable to install the oven so that it rests on two wooden slats. If the oven rests on a
flat surface, there must be an opening of at least 45×560 mm. Fig. 4
Adjacent cabinet panels shall be made of heat-resistant material. In particular,
-
enclosures with a veneered exterior must be assembled with glues that can withstand
temperatures up to 100 ℃.
In compliance with current safety regulations, it must not be possible to come into
-
contact with the electrical parts of the oven once it has been installed. All parts that
ensure the safe operation of the appliance must only be removed with the aid of a tool.
To fix the oven to the cabinet, open the oven door and fix it by inserting the 4 wood
-
screws into the 4 holes on the perimeter of the frame.
52
Publicité
