Kohler K-1800 Guide D'installation Et D'entretien page 4

Drain Pipe
2. Install the Bath
CAUTION: Risk of property damage. Make sure the factory-installed drain connections have not
become loose during shipping. Tighten as needed to prevent leakage.
CAUTION: Risk of personal injury. This bath is extremely heavy. Obtain sufficient help and use
lifting straps to carefully lift or move the bath.
Stack together two 6' (1.8 m) lengths of 2x4 lumber. Secure each set of stacked 2x4's together with
nails or screws.
Position the stacked 2x4's on each side of the drain pipe to temporarily support the bath.
With help, use lifting straps to carefully lift the bath into position on the 2x4's so the bath drain is
over the drain pipe.
Carefully reposition the bath as needed so the bath drain is directly over the drain pipe.
Use lifting straps and get additional assistance to remove the 2x4 supports and carefully set the bath
on the floor. Adjust the bath position as needed to ensure that the drain pipe is in the center of the
bath drain hole.
Verify that the bath is level and that all support feet are in contact with the finished floor. Carefully
install shims under the support feet as needed.
1207308-2-A
Align.
Drain Pipe
2x4's
4
Level
Bath Drain
Kohler Co.