Télécharger Imprimer la page

Candy Smart CSE C8LF-S Mode D'emploi page 61

Publicité

Les langues disponibles
  • FR

Les langues disponibles

WARNING
Don't touch the buttons while inserting
the
plug
because
calibrates the systems during the first
seconds: touching the buttons, the
machine couldn't work property. In
this case, remove the plug and repeat
the operation.
PROGRAMME SELECTOR with
OFF position
l
Rotating the programme selector in both
directions it's possible to select the
desired drying programme.
l
To cancel the selections or switch off the
appliance rotate the programme selector
on OFF (remember to unplug the
appliance).
START/PAUSE button
Close the porthole BEFORE pressing
the START/PAUSE button.
l
Press the START/PAUSE button to start
the programme set with the programme
knob (the corresponding indicator light
will light up).
l
Moreover, if you want to modify the
chosen programme, press the desired
options buttons and then press START/
PAUSE button to start the cycle.
Only the options compatible with the
set programme can be selected.
l
After switching on the appliance, wait a
few seconds for the programme to start
running.
the
machines
61
PROGRAMME DURATION
l
When a programme is selected the
appliance calculates the time to the end
of the selected programme based upon a
standard loading but, during the cycle, the
appliance
corrects
humidity level of the load.
PROGRAMME END
l
The "END" indicator light will light up at
the end of the programme, it is now
possible to open the door.
l
At the end of the cycle, turn off the
appliance by turning the programme
selector to the OFF position.
The
programme
ALWAYS be put in the OFF position at
the end of the drying cycle before a
new one can be selected.
PAUSING THE MACHINE
l
Press the START/PAUSE button (the
corresponding indicator light will flash,
showing that the machine is paused).
l
Press the START/PAUSE button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
l
To cancel the programme, turn the
programme selector to the OFF position.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, by pressing the
START/PAUSE button, the machine will
restart from the beginning of the phase it
was in when the power was lost.
DELAY START button
l
Appliance start time can be set with this
button, delaying the start by 3, 6 or 9
hours.
the
time
to
the
selector
must

Publicité

loading