AKO 15645 Guide Rapide page 21

6.- Instalation
Panel assembly
A
E
-Remove the connections cover (D).
-Separate the front (B) from the box (A).
-Choose the most suitable cable entry for the facility (fig. 2, page 2).
-Make the holes for the glands using the pre-drilled centres as a guide.
-Drill 3 holes on the wall following the box fixing holes (E)
-Fasten the box to wall inserting and tightening 3 screws + plug (F).
-Insert the cables through the glands.
Only AKO-15648
-Connect the defrost resistors to the contactor K1 output (terminals L1 to L4). Next connect the three-phase power
supply cables to F1 circuit breaker and make the connections shown in the connection diagram.
-Position flanges according to figure 5 (page 2) and connect the power supply cable (I) to the device's input.
Only AKO-15645 / AKO-15646
-Connect the power supply to the FM circuit breaker as indicated in the wiring diagrams and position the flanges
according to figure 4 (page 2). Connect the power supply cable (I) to the device's input.
Only AKO-15626 / AKO-15627
-Connect the power supply (230V AC) to the input of the equipment using the removable terminal as shown in the
connection diagrams.
ALL
-Assemble the front on the box (B) carefully making sure that the cables are not pinched.
-Insert and tighten the two screws on the front (G).
Sólo AKO-15648
-Connect the cables of K1 contactor coil (red cables) to terminals 17 and 18.
ALL
-Connect the rest of the wiring following the diagrams in section 7 and position the flanges according to figure 3
(page 2).
-Join all the grounding connections to the supplied terminal.
-Close the connections cover (D), insert and tighten the fixing screws (H).
(fig. 1)
F
I
G
21
B
M
C
D
H