Publicité
Les langues disponibles
Les langues disponibles
4.3 Switching on
To switch the heating pad on, set the sliding switch for ON/OFF and temperature settings to setting 1, 2 or 3. The temperature setting
is illuminated when switched on.
4.4 Setting the temperature
Setting 0:
OFF
Setting 1:
minimum heat
Setting 2:
medium heat
Setting 3:
maximum heat
NOTE
The fastest way to warm up the heating pad is to initially set the highest temperature setting of the controller, first.
NOTE
This heating pad has a turbo function, which allows the heating pad to warm up faster in the first 10 minutes.
CAUTION
If the heating pad is being used over several hours it is
recommended to set the lowest temperature setting (1) on the
controller to avoid overheating the heated body part, which may
lead to burns to the skin.
4.5 Automatic switch-off
This heating pad is equipped with an automatic switch-off function. This turns off the heat supply approx. 90 minutes
after the initial use of the heating pad. The temperature setting display then starts to flash. So that the heating pad can
be switched back on, the sliding switch for ON/OFF and temperature settings must first be set to setting 0 (OFF). After
about 5 seconds it is possible to switch it on again.
4.6 Switching off
To switch the heating pad off, set the sliding switch for ON/OFF to setting 0 (OFF) position. The temperature settings are then no
longer illuminated.
NOTE
If the heating pad is not in use, switch the side sliding switch for ON/OFF and temperature settings to the OFF (0) position
and remove the mains plug from the socket. Then disconnect the controller from the heating pad by unplugging the plug-in
coupling.
5
cleaning & maintenance
WARNING
Before cleaning, always remove the mains plug from the socket first. Then disconnect the controller from the heating pad by
unplugging the plug-in coupling. Otherwise there is a risk of electric shock.
CAUTION
• The controller must never come into contact with water or other liquids. Otherwise, the controller may be damaged.
To clean the controller, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
Small marks on the heating pad can be removed with a damp cloth or sponge, or if necessary, with a little liquid detergent for delicate
laundry.
14
•
English
Publicité
