Publicité
Les langues disponibles
Les langues disponibles
Settings
6.
Water hardness
7.
TAB
(All-in-one detergent)
8.
Super rinse
9.
Failure readout
10.
Factory reset
11.
Exit
Alternatives
0/1/2/3/4/5/6/7/8/9
On/Off
On/Off
Build-up of foam. If you have very soft
water, the rinse aid can be diluted 50:50
with water.
Adjusting the water softener. Select a setting
depending on the hardness of the water
supply. It is important that this setting is
correct!
See Water hardness in the chapter Before
washing for the first time.
For a water supply with a hardness above
5 °dH (9 °fH / 6 °eH / 0.9 mmol/l), fill with salt.
For a water supply with a hardness below
6°dH (10°fH / 7°eH / 1.0 mmol/l), select 0.
The water softener is deactivated and no salt
needs to be added.
Activate this setting when using an all-in-one
detergent that contains rinse aid.
This setting reduces the rinse aid dosage
and affects how often the dishwasher's
built-in softener is regenerated.
The Super rinse function rinses the dishes an
extra two times.
The program time is extended and the
dishwasher uses more energy and water.
Activated in the following programs:
Universal
Intensive
Quick
Hygiene
Any error messages.
When contacting your service centre, you
may be asked to provide the most recent
error messages.
Restores all settings to the factory defaults.
Select Factory reset and press
To exit the dishwasher's Settings menu,
select Exit and press
Settings
.
.
23
Publicité
