Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
Water leaking from the
refrigerator.
The door does not open
easily.
Some or all of the LED lighting
does not work.
Appliance makes a noise.
Error code E0, E1 or E2 is
shown in the display.
If you are unable to solve the problem then contact the service centre. When you do so, state the
type, model and serial number shown on the type plate or label on the inside of the appliance.
• Clogged water discharge opening or water dripping past
the water gutter.
• Clean the clogged opening, for example using a plastic
straw.
• If a thick layer of ice builds up, defrost the appliance
manually (see 'Defrosting the Appliance').
• You are trying to open the appliance's door just after
you have closed the door. Then opening the door is
difficult. When you open the door, cold air escapes
from the appliance and is replaced by warm air from the
surroundings. As this air cools a slight vacuum is created
that makes it more difficult to open the door. The situation
returns to normal after a few minutes, and the door opens
easily again.
• Consult a service technician about LED lighting that is not
working. For safety reasons, you are not allowed to repair
LED lighting yourself.
• This product contains a light source of energy efficiency
class G.
• The appliance is cooled by a refrigeration system with a
compressor (and with some models, also a fan) that makes
a noise. The noise level depends on the installation of the
appliance, its correct use and its age.
• When you connect the appliance to the power supply the
noise made by the compressor or flowing refrigerant may
be slightly louder. This is not indicative of a defect, and has
no effect on the service life of the appliance. The appliance
will make less noise after a while.
• The appliance may be temporarily noisier after the door has
been opened for too long or too frequently, a large quantity
of fresh food has been put in the appliance or the intensive
freezing or intensive cooling function has been activated.
• A sensor is defective. Call the service centre to make an
appointment for repair work. The appliance operates in
the safe mode until it has been repaired. The appliance
automatically retains the most suitable temperature for
each compartment.
EN 25
Publicité
