Publicité
Les langues disponibles
Les langues disponibles
Problem
There are rust stains on the dishes.
FAULT CODES
The fault codes are shown on the display of the control panel.
Program selector
Possible cause
button
Quick '30, blinks
There is insufficient water
supply.
Quick '30 and Quick
The heater has an error.
'90, blinks
Eco, blinks
The safety for water overflow is
activated.
9
General terms and conditions of service and warranty
We do not need to remind you of the importance of service. After all, we develop our products to a standard so that
you can enjoy them for many years, without any concerns. If, nevertheless, there is a problem, we believe you are
entitled to a solution straight away. Hence our products come with an exchange service, on top of the rights and
claims you are entitled to by law. By exchanging a product or part, we save you time, effort and costs.
2-year full manufacturer's warranty
1. Customers enjoy a 2-year full manufacturer's warranty on all Inventum products. Within this period, a faulty
product or part will always be exchanged for a new model, free of charge. In order to claim under the 2-year full
manufacturer's warranty, you can either return the product to the shop you bought it from or contact the Inventum
costumer service department via the form at
2. The 2-year warranty period starts from the date the product is bought.
3. In order to claim under the warranty, you must produce a copy of the original receipt.
4. The warranty applies only to normal domestic use of Inventum products within the Netherlands.
Possible cause
The appliance is unloaded too
quickly after the program is finished.
The stainless steel quality of the
dishes is insufficient.
The level of salt consumption is set
too high.
The cap of the salt reservoir is not
closed correctly.
Any spilled salt during filling of the
salt reservoir was not cleaned
immediately.
The water supply is polluted.
Possible solution
•
Make sure that the water tap is fully open and that
the water supply is not blocked.
•
Close the water tap, remove the water inlet hose and
do a check if the hose is clogged.
•
Start the appliance again.
•
Contact the Inventum-servicedienst if the fault code
keeps re-occuring.
Contact the Inventum-servicedienst.
Contact the Inventum-servicedienst.
'https://www.inventum.eu/service-aanvraag'
Possible solution
Wait a few minutes after the program
is finished before you unload the
appliance.
Make sure that you only clean
dishwasher-safe dishes in the
appliance.
Adjust the level of salt consumption.
Refer to section
'Setting the level of
salt consumption'
.
Make sure that the cap of the salt
reservoir is closed firmly.
Make sure that you clean any spilled
salt immediately and run a full
program to prevent corrosion.
Do a check on the water supply.
.
English
•
45
Publicité
