Publicité
Les langues disponibles
Les langues disponibles
7
Extra information
WATER HARDNESS LEVEL SETTINGS (SALT CONSUMPTION)
Level
German hardness
[dH]
H1
0-5
H2
6-11
H3
12-17
H4
18-22
H5
23-34
H6
35-50
8
Troubleshooting
GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table and the fault codes.
2. If the fault code keeps re-occuring, contact the Inventum-servicedienst.
TROUBLESHOOTING TABLE
Problem
The program does not start.
The detergent reservoir contains
detergent residues.
The appliance contains water when
the program is finished.
The appliance stops during a
program.
French hardness [dF]
British hardness [dE]
0-9
0-6
10-20
7-14
21-30
15-21
31-40
22-28
41-60
29-42
61-90
43-63
Possible cause
The mains plug is not connected.
There is a problem with the fuse.
There is no water supply.
The door of the appliance is open.
The appliance is switched off.
The water inlet hose and filters are
clogged.
The detergent reservoir is filled while
the reservoir was still damp.
The drain hose is clogged or twisted. •
The filters are clogged.
The program has not finished.
There is a power failure.
There is a water inlet failure.
The program is paused.
Program selector button on
Quick '30, on
Quick '90, on
Quick '90 and Quick '30, on
Eco, on
Eco and Quick '30, on
Eco and Quick '90, on
Possible solution
Connect the mains plug.
Do a check on the fuse box.
Open the water tap.
Close the door.
Start the appliance. Refer to section
'Starting the appliance'
.
Make sure that the water inlet hose
and the filters are not clogged.
Make sure that you fill the detergent
reservoir when it is dry.
Make sure that the drain hose is
not clogged.
•
Make sure that the drain hose is
not twisted.
Clean the filters. Refer to section
'Cleaning the filters'
.
Wait until the program is finished.
A buzzer sounds five times when the
program is finished.
Make sure that there is power.
Make sure that there is water inlet
supply.
Start the program.
English
•
43
Publicité
