Télécharger Imprimer la page

Philips HU5931 Mode D'emploi page 13

Masquer les pouces Voir aussi pour HU5931:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

5
Wipe the outside of the water tank
and water tray dry.
6
Place the wick wheel on the wick
support (fig. k).
Note
When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
7
Place the water tray back into the
appliance (fig. l).
8
Place the water tank back into the
appliance (fig. p).
Cleaning the pre-filter
Filter alert light
status
Cleaning light
goes on (fig. )
Note
Only the pre-filter and NanoCloud
rotary humidification wick are
washable. The NanoProtect filter is
not washable.
1
Pull the top part of the back panel
towards you to release it from the
appliance (fig. c).
2
To remove the pre-filter, press the
two clips down and pull the filter
towards you (fig. €).
3
Wash the pre-filter under a running
tap. If the pre-filter is very dirty, use
a soft brush to brush away the dust
(fig. ).
4
Air dry the pre-filter.
Follow this
Clean the pre-
filter
Note
Make sure that the pre-filter is
completely dry. If it is still wet,
bacteria may multiply in it and
shorten the lifetime of the pre-filter.
5
After the pre-filter is completely dry,
place it back into the back panel
(fig. ‚).
6
Touch and hold the reset button
for 3 seconds to reset the pre-filter
cleaning time (fig. ƒ).
Descaling the
NanoCloud rotary
humidification wick
Filter alert light
status
Cleaning light
goes on (fig. )
1
Pull out the water tank (fig. h).
2
Pull out the water tray (fig. }).
3
Take the wick wheel off the wick
support (fig. ~).
4
Soak the NanoCloud rotary
humidication wick in cleansing
agent (e.g diluted white vinegar,
Citric acid solution) for two hours.
Follow this
Descale the
NanoCloud rotary
humidification
wick
EN
11

Publicité

loading

Ce manuel est également adapté pour:

Hu5930Hu5931/11