Publicité
Les langues disponibles
Les langues disponibles
Adjusting the
base plate
Sawdust removal
Anti–splintering
device
Adjusting the
stroke rate
ENGLISH
The base plate can be tilted or moved backward or forward.
Setting an angle
Loosen the fixing screw, pull the base plate out of the mounting, set it at the
required angle (15
screw again. Angles other than 45
into the mounting.
The angle can be read off the scale.
For very exact angle cuts it is
recommended to make a test cut.
Moving the base plate
cuts or cuts in corners.
Loosen the fixing screw, push the base
plate to the rear and tighten the fixing
screw again. The base plate in this
position is fixed at the 0
Moving back
short saw blade and sawing near the
edge.
Take the fixing screw out, push the base
plate to the rear and screw the fixing screw tightly into the rear hole.
In this position the base plate can also be off-set in longitudinal direction.
Only operate the machine with suitable
sawdust removal.
The integrated suction channel has the
standardized internal diameter of 30 mm.
Use the suction hose (Id. No.
4932 3304 12) from our range of
accessories to connect it to a household
vacuum cleaner or to an wet-and-dry
vacuum cleaner.
1.
Push in and turn the suction hose into the suction
channel until it fits firmly.
2.
Push the transparent cover downwards to ensure
optimum sawdust removal.
The anti-splintering device almost entirely
prevents the edge of the wood from
splintering.
Place the anti-splintering device as shown
in the illustration with the smooth side
downwards and flush with the base plate
(this is only possible with the base plate in
the forward position).
The stroke-rate (= movements per minute
of the saw blade) can be infinitely varied
by means of the adjustment wheel.
The letters A to G are printed on the speed
control, meaning:
A = lowest stroke rate
G = highest stroke rate
3
For angle cuts and bevels.
o
o
o
, 30
, 45
), push it back into the mounting and tighten the fixing
o
can be set by not pushing the base plate back
For plunge
o
setting.
For cutting a hole with a
STEP 570 X, STEP 600 X
I I I
Publicité
