Krups BLENDER PERFECT MIX KB403 Mode D'emploi page 20

WHAT TO DO IF YOUR APPLIANCE DOES NOT WORK
PROBLEMS
Appliance does not work
The appliance stopped
while in use
Excessive vibrations
Leak from the lid
Leak at the bottom of the
blender jug
The blade does not turn
easily
YOUR APPLIANCE STILL DOES NOT WORK?
Contact an approved service centre (see list in service booklet).
17
CAUSES
The plug is not connected
The blender jug is not
positioned correctly on the
motor unit
Overload
The product is not placed
on a flat, stable surface
Volume of ingredients is too
high
Volume of ingredients is too
high
The lid is not correctly
positioned
The blender seal (F3)
is not positioned correctly
or is absent
Pieces of food are too large
or too hard. Liquid has been
blended that was too hot
and has distorted the seal
SOLUTIONS
Connect the appliance to
a socket with the same
voltage as that on the rating
plate of the appliance.
Check that the blender jug
is positioned properly on the
motor unit as explained in
the instructions.
Follow the instructions
in section USING YOUR
BLENDER.
The cooling time is
variable and can last up to
30 minutes
Place the appliance on
a flat surface.
Reduce the quantity of
ingredients processed.
Reduce the quantity of
ingredients processed.
Place the lid correctly on the
blender jug.
Reposition the seal with
the correct side uppermost
(Fig. 11) and lock the
assembled blade unit
(F1+F2+F3) onto the
blender jug correctly (Fig. 1,
Fig. 2 & Fig. 3)
Replace the seal with a
new one. Reduce the size
or quantity of ingredients
processed. Add liquid.