Krups BLENDER PERFECT MIX KB403 Mode D'emploi page 17

„ Make sure the locking ring is locked correctly : the two arrows must be aligned (Fig 3).
„ Add the ingredients to the assembled jug without exceeding the maximum level indicated:
* 1.5 L for thick mixtures
* 1.25 L for liquid preparations
Warning : Do not pour boiling liquids (over 80°C/176°F) into the jug.
„ Fit the lid (F5) on the jug (Fig. 8). To avoid any splashes during blending make sure that
the curved tabs on the lid are aligned with the spout and handle (Fig. 9) . Fit the measuring
cap (F6) in the hole on the lid (Fig. 8)
„ Once the blender jug is locked correctly on the motor unit, plug in the appliance. The
lights on the appliance flash twice and you hear a beep. Turn it on using the desired
function.
„ Speed selection: Turn the control knob (E) to choose the desired speed; the speed
increases gradually between min and max. The intensity of the lights on the appliance
increase gradually as the speed increases. You can change the speed as required during
preparation.
„ "Pulse" function: Turn the control knob (E) to the "Pulse" position. Using a succession
of pulses gives finer control for precise preparations. In this position, the appliance starts
directly on maximum speed. It stops as soon as you release the knob. The light remains
on when the pulse function is in use.
„ Function " Smoothie"
This function is used to prepare smoothies, milkshakes and fruit cocktails. The speed
is pre-programmed for best results. To use this function, press the "Smoothie" button
(B). The light remains on during this cycle and switches off when the cycle is finished.
The program stops automatically and beeps 4 times. You can stop it before the end by
pressing the "Smoothie" button (B) again.
„ Function " Ice crush"
You can use this function to crush ice finely with pre-programmed operating cycles and
speed. To use this function, press the "Ice crush" button (C). The light remains on during
this cycle and switches off when the cycle is finished. You hear 4 beeps. The program
stops automatically but you can stop it before the end by pressing the "Ice crush" button
(C) again.
„ Function "Auto clean":
This function is used to automatically clean your appliance. Press the "Auto clean"
button (D). Do not exceed 1 litre of hot water (maximum temperature of 80°C / 176°F). At
the end of the program, the appliance stops automatically and you hear 4 beeps.
„ WARNING : If the load becomes too high, your appliance will stop automatically for
safety reasons (if the motor runs for more than 3 minutes or if you have used too
much ingredients). To restart your appliance, turn the control knob to
cooling time may vary and can be up to 30 minutes. Before restarting your appliance,
adapt the quantity of ingredients or blending time to avoid any overload. You can then
select the desired speed or function to complete your preparation.
„ WARNING : Do not use the program functions smoothie, ice crush and auto clean
with the herb chopper (K) and spice grinder (L).
These programs can only be used with the blender jug (F). Do not perform ice crush with
the herb chopper (K) and spice grinder (L).
USING YOUR BLENDER
. The overall
14