Tineco CARPET ONE Serie Mode D'emploi page 33

4.Rinse with water. Allow it to dry completely
before reinstalling.
Fig.D-17
5.Reinstall.
Fig.D-18
Humidity Sensor
• Clean the humidity sensor after each use,
rotate the sensor several times or use the
cleaning tool. Also clean the bristle after each
use.
Fig.D-19
SCAN THE QR CODE BELOW TO
GET PRODUCT CARE VIDEOS.
TROUBLESHOOTING
Problem
The appliance does
not turn on
Accessory icon: blinks
Spray volume
indicator: solid "0"
Voice prompt:
Stand the appliance
upright
AUTO icon: blinks
Spray volume
indicator: solid "0"
Voice prompt:
Stand the appliance
upright
Solution
Ensure that the socket
is energized and the
power cord is plugged
in
Stand the appliance
upright, then enter the
ACCESSORY mode
Stand the appliance
upright to end the
accessory hose
removal. Then tilt the
appliance again to
enter AUTO mode
Problem
LED loop illuminates
red
Voice prompt:
Clean the channel
under the dirty water
tank
CWT empty indicator
blinking
Voice prompt:
Pleasde add clean
water or solution to
clean water tank
DWT full indicator
blinking
Voice prompt:
1.Dirty water tank full,
please empty
2.Please check the dirty
water tank
Brush roller tangled
indicator blinking
Voice prompt:
1.Please clean the
brush roller
2.Please install the
brush roller cover
No spray volume
display
Dryness indicator
blinks
Voice prompt:
Humidity Display
malfunction, please
contact customer
service
Note:
If the above troubleshooting guide fails to
provide a solution, please visit our website
www.tineco.com for further support.
31
Solution
1.Remove blockages
2.Clean the debris
channel
3.Clean the sponge
filter
Refill CWT
1.Empty the dirty water
and then reinstall the
DWT
2.Check if the floater
is in good condition
and press it to the
bottom
3.Remove blockages
1.Remove blockages
2.Install brush roller
cover correctly
Contact Customer
Service
Contact Customer
Service